DSM-G600, DNS-3xx and NSA-220 Hack Forum

Unfortunately no one can be told what fun_plug is - you have to see it for yourself.

You are not logged in.

#1 2016-08-12 09:40:33

enoch81
Member
Registered: 2016-08-12
Posts: 5

DNS 320 rev. A1 Bricked... help please!

After the upgrade to ALT-F RC5 my box doesn't work anymore.
I soldered the jtag header and once connected via tty i can't reach the u-boot command prompt.
I can't stop the autoboot.
I tryed almost every space +1 combination.


This is the console output

Code:

** MARVELL BOARD: DB-88F6281A-BP LE

U-Boot 1.1.4 (Jan 21 2011 - 11:56:48) Marvell version: 3.4.14.DNS-320_03

U-Boot code: 00600000 -> 0067FFF0  BSS: -> 006CEE80

Soc: MV88F6281 Rev 3 (DDR2)
CPU running @ 800Mhz L2 running @ 400Mhz
SysClock = 200Mhz , TClock = 166Mhz

DRAM CAS Latency = 3 tRP = 3 tRAS = 8 tRCD=3
DRAM CS[0] base 0x00000000   size 128MB
DRAM Total size 128MB  16bit width
Flash:  0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:128 MB
*** Warning - bad CRC or NAND, using default environment


CPU : Marvell Feroceon (Rev 1)

Streaming disabled
Write allocate disabled


USB 0: host mode
PEX 0: interface detected no Link.
Net:   egiga0 [PRIME]
Hit any key to stop autoboot:  0

There, i can't stop the kernel loading sequence.

and after that, what Ill have to do?

Offline

 

#2 2016-08-23 00:37:43

enoch81
Member
Registered: 2016-08-12
Posts: 5

Re: DNS 320 rev. A1 Bricked... help please!

Ok, actually I can reach the webpage of ALT- but, when I try to upgrade the firmware, It print at screen "unsupported unknown board".
But I've used this NAS with the RC4 for two years.
It's possible to FORCE the firmware through the webpage?
Thank you

Offline

 

Board footer

Powered by PunBB
© Copyright 2002–2010 PunBB